To study axial/radial profiles of particle velocity in the affected region of an integrated riser outlet,a cold model was developed for the integrated riser reactor combining the gas-solid distributor with the fluidized bed.Constraints,related to the gas-solid distributor and the upper fluidized bed,imposed on the particle flow in the riser outlet region,were investigated experimentally.The experimental results showed that with increasing superficial gas velocity,these constraints have strong influences on particle flow behavior,the particle circulation flux in the riser,and the height of the static bed material of the upper fluidized bed.When the constraints have greater prominence,the axial profile of the cross-sectionally averaged particle velocity in the outlet region initially increases and then decreases,the rate of decrease being proportional to the constraint strength.Along the radial direction of the outlet section,the region where the local particle velocity profile tends to decrease appears near the dimensionless radius r/R = 0.30 initially and then,with increasing constraint strength,gradually extends to the whole section from the inner wall.Based on the experimental data,an empirical model describing the constraint strength was established.The average relative error of the model is within 7.69%.
The hydrodynamics in a gas-solid airlift loop reactor was investigated systematically using experimental measurements and CFD simulation.In the experiments,the time averaged parameters,such as solid fraction and particle velocity,were measured by optical fiber probe.In the simulation,the modified Gidaspow drag model accounting for the interparticles clustering was incorporated into the Eulerian-Eulerian CFD model with particulate-phase kinetic theory.Predicted values of solid fraction and particle velocity were compared with experimental results,validating the drag model and the simulation.The results show that the profiles of particle velocity and solid fraction are uniform in annulus.However,the core-annulus structure appears in other three regions (draft tube region,bottom region and particle diffluence region),which presents the similar heterogeneous feature of aggregative fluidization usually occurred in normal fluidized beds.Simulated profiles of particle residence time distribution indicate that the airlift loop reactor should be characterized by near perfect mixing.
Chaoyu Yan Chunxi Lu Yiping Fan Rui Cao Yansheng Liu
