Magnetism induced by the nonmagnetic dopants in the zinc-blende SiC (3C-SiC) is investigated by first-principle calculations. The atoms of the first 20 elements in the periodic table except inert gas are used to replace either Si or C atoms as dopants. We find that some nonmagnetic substitutional dopants (mainly the Group IA, Group IIA, Group IIIB, and Group VIIB elements) prefer the spin-polarized ground states with local magnetic moments. In general, the condition for obtaining the local magnetic moments and the magnetic ground state requires that the dopants are p-type and have large electronegativity difference from the neighboring host atoms. The magnetic moments can be tuned over a range between 1 μ B and 3 μ B by doping with the nonmagnetic elements. The nearest-neighbor exchange couplings J 0 between the local magnetic moments are quite large and the codoping method is proposed to increase the dopant concentration. These imply that the nonmagnetic doping in SiC may exhibit collective magnetism. Moreover, the Group IIA Mg and Ca atoms substituting the preferred Si atoms favor the ferromagnetic ground states with the half-metallic electronic properties, which suggests that Mg or Ca substitutional doping on the Si sites in SiC could be a potential route to fabricating the diluted magnetic semiconductors.
LIU ZhaoQing & NI Jun Department of Physics and Key Laboratory of Atomic and Molecular Nanoscience (Ministry of Education), Tsinghua University, Beijing 100084, China
We develop a general approach to the fabrication of films with unidirectional grooves,such as silicon nitride, silicon dioxide and aluminium oxide,in which the surface is not required to be treated.Super-aligned carbon nanotube (SACNT) film may be used as a template and as sacrificial layer,which is subsequently removed by heating in an atmosphere of air.The unidirectional morphology of the SACNT film turns into a desired film,which is found to possess the ability to align liquid crystal molecules.This approach also features high efficiency,low cost and easy scaling-up for mass production.
