A recursive formulation is proposed for the method of reverberation-ray matrix (MRRM) to exactly analyze the free vibration of a multi-span continuous rectangular Kirchhoff plate, which has two oppo- site simply-supported edges. In contrast to the traditional MRRM, numerical stability is achieved by using the present new formulation for high-order frequencies or/and for plates with large span-to-width ratios. The heavy computational cost of storage and memory are also cut down. An improved recursive formulation is further proposed by modifying the iterative formula to reduce the matrix inversion op- erations. Numerical examples are finally given to demonstrate the effectiveness and efficiency of the proposed recursive formulae.
Semi-analytical elasticity solutions for bending of angle-ply laminates in cylindrical bending are presented using the state-space-based differential quadrature method (SSDQM). Partial differential state equation is derived from the basic equations of elasticity based on the state space concept. Then, the differential quadrature (DQ) technique is introduced to discretize the longitu- dinal domain of the plate so that a series of ordinary differential state equations are obtained at the discrete points. Meanwhile, the edge constrained conditions are handled directly using the stress and displacement components without the Saint-Venant principle. The thickness domain is solved analytically based on the state space formalism along with the continuity conditions at interfaces. The present method is validated by comparing the results to the exact solutions of Pagano’s problem. Numerical results for fully clamped thick laminates are presented, and the influences of ply angle on stress distributions are discussed.
The bending problem of a functionally graded anisotropic cantilever beam subjected to a linearly distributed load is investigated.The analysis is based on the exact elasticity equations for the plane stress problem.The stress function is introduced and assumed in the form of a polynomial of the longitudinal coordinate.The expressions for stress components are then educed from the stress function by simple differentiation. The stress function is determined from the compatibility equation as well as the bound- ary conditions by a skilful deduction.The analytical solution is compared with FEM calculation,indicating a good agreement.
