Based on the interpretation of two-dimensional seismic data, this paper analyzes the characteristics of three boundary fault systems including the Shajingzi fault, the Aqia fault and the Tumuxiuke fault around the Awati sag of the Tarim Basin, and studies its controlling on hydrocarbon accumulation. Neotectonic movement is ubiquitous in oil and gas bearing basins in China, such as Neogene intense activities of large boundary thrusting faults of the Awati sag: Shajingzi fault, Aqia fault and Tumuxiuke fault. Based on a large number of seismic data, it is showed that they have section wise characteristics in the direction of fault strike, and active periods and associated structures formed of different sections are different. Usually, large anticlinal structures are formed in the upper wall, and faulted anticline controlled by companion faults are formed in the bottom wall. Large faults cut the strata from Cambrian up to Neogene. For the anticline in the upper wall, fault activities caused by neotectonic movement played a destructive role in hydrocarbon accumulation, thus the preservation condition is critical for reservoir formation. In this sense, attention should be paid to formations in the upper walls of Aqia fault and Tumuxiuke fault under the Cambrian salt bed, whose plastic deformation could help to heal faults. Companion faults in the bottom wall cut down to the Cambrian and up to the Triassic serving as the pathway for hydrocarbon migration, and associated structures in the bottom wall are noteworthy exploration targets.
Hydrothermal mineral assemblages and related hydrothermally enhanced fracturing are common in the Precambrian Dengying Formation of Central Sichuan Basin. Petrographic and geochemical analyses of core samples show that the hydrothermal dolomite reservoirs of Dengying Formation consist of four main types of pores in the reservoir facies. These include: 1) hydrothermal dissolution vug(or pore), 2) intercrystalline pore, 3) residual inter-breccia vug(or pore), and 4) enlarged dissolved-fracture. There are three different fabrics dolomite in hydrothermal dolomite reservoirs, namely, saddle dolomite, fine-medium dolomite and micritic dolomite. Micritic dolomite is the original lithology of host rock. Saddle dolomite with curved or irregular crystal faces was directly crystallized from hydrothermal fluids(average temperature 192°C). Fine-medium dolomites are the products of recrystallization of micritic dolomite, resulting in abnormal geochemical characteristics, such as slight depletion of δ^(18)O, significant enrichment of Mn-Fe and ^(87)Sr/^(86)Sr, and positive Eu anomaly. A model for the distribution of various hydrothermal dolomite reservoir facies is proposed here, which incorporates three fundamental geological controls: 1) extensional tectonics and tectono-hydrothermal events(i.e., the Xingkai Taphrogenesis of Late Sinian-Early Cambrian, and Emei Taphrogenesis of Late Permian), 2) hydrothermal fluid storage in clastic rocks with large thickness(e.g., Nanhua System of Chengjiang Formation and part of Doushantuo Formation), and 3) confining bed for hydrothermal fluids(such as, the shale in Qiongzhusi Formation). The supply of hydrothermal fluid is critical. Large basement-rooted faults and associated grid-like fracture system may function as the channels for upward migration of hydrothermal fluid flow. The intersection of the above-mentioned faults(including the conversion fault), especially transtensional sags above negative flower structures on wrench faults can serve as a key target for future hydrocarbon ex
Despite the absence of regional cap rocks in the Lower Paleozoic for the entire Tazhong Low Rise, several sets of effective local cap rocks are well preserved on the Northern Slope. Of these the best is the Ordovician mudstone of the Sangtamu Formation; the second is the Silurian Red Mudstone Member of the Tatairtag Formation and the marl of the Ordovician Lianglitag Formation; and the third is the gray mudstone of the Silurian Kepingtag Formation. The dense limestone of the Ordovician Yingshan Formation and the gypsum of the Middle Cambrian have shown initial sealing capacity. These effective cap rocks are closely related to the distribution of Lower Palaeozoic hydrocarbons in the Tazhong Low Rise. With well-preserved Sangtamu Formation mudstone and its location close to migration pathways, rich Lower Paleozoic hydrocarbon accumulation can be found on the Northern Slope. Vertically, most of the reserves are distributed below the Sangtamu Formation mudstone; areally, hydrocarbons are mainly found in the areas with well-developed Sangtamu Formation mudstone and Lianglitag Formation marl. Burial history and hydrocarbon charging history show that the evolution of Lower Palaeozoic cap rocks controlled the accumulation of hydrocarbon in the Tazhong Low Rise. Take the Red Mudstone Member of the Tatairtag Formation and Sangtamu Formation mudstone for examples: 1) In the hydrocarbon charging time of the Late Caledonian-Early Hercynian, with top surfaces at burial depths of over 1,100 m, the cap rocks were able to seal oil and gas; 2) During the intense uplifting of the Devonian, the cap rocks with top surfaces at burial depths of 200-800 m and 500-1,100 m respectively were denuded in local areas, thus hydrocarbons trapped in earlier time were degraded to widespread bitumen; 3) In the hydrocarbon charging time of the Late Hercynian and Himalayan, the top surfaces of the cap rocks were at burial depths of over 2,000 m without intense uplifting and denudation thereafter, so trapped hydrocarbons were preserved. Based on cap
