Free-interface dual-compatibility modal synthesis method(compatibility of both force and displacement on interfaces)is introduced to large-scale civil engineering structure to enhance computation efficiency. The basic equations of the method are first set up, and then the mode cut-off principle and the dividing principle are proposed. MATLAB is used for simulation in different frame structures. The simulation results demonstrate the applicability of this substructure method to civil engineering structures and the correctness of the proposed mode cut-off principle. Studies are also conducted on how to divide the whole structure for better computation efficiency while maintaining better precision. It is observed that the geometry and material properties should be considered, and the synthesis results would be more precise when the inflection points of the mode shapes are taken into consideration. Furthermore, the simulation performed on a large-scale high-rise connected structure further proves the feasibility and efficiency of this modal synthesis method compared with the traditional global method. It is also concluded from the simulation results that the fewer number of DOFs in each substructure will result in better computation efficiency, but too many substructures will be time-consuming due to the tedious synthesis procedures. Moreover, the substructures with free interface will introduce errors and reduce the precision dramatically, which should be avoided.
The magnetorheological (MR) fluid damper-based semiactive control systems have received considerable attention for protecting structures against natural hazards such as strong earthquakes and high winds. In this paper, a novel modal controller using wavelet packet transform (WPT) is proposed for the vibration control of distributed structures. In the proposed control system, the WPT method is utilized to decompose the acceleration measurement and select the modes containing most of the WPT energy component as the dominant modes. Then, a modal controller is designed to control the dominant modes and the optimal active control force is solved. Finally, Clipped-optimal con- trol law is adopted to determine the voltage applied to each MR damper. A Kalman-filter observer, which estimates the full controlled modal states from local accelerometer feedbacks, is designed for rendering the controller to be more applicable to distributed structures with a large number of degrees of freedom. A numerical example of a stadium roof structure installed with MRF-04K damper is presented. The effectiveness of the controller is evaluated under both Tianjin and El Centro earthquake excitations. The superior performance and adaptability of the controller for versatile loading conditions are demonstrated through the comparison with traditional truncated modal controller.
