Compositing soft and hard materials is a promising method to decrease the coercivity of L10 FePt, which is considered to be a suitable material for bit-patterned media. This paper reports the simulation of three models of FeCo/L10 FePt exchange-coupled composite particles for bit patterned media by the OOMMF micromagnetic simulation software： the enclosed model, the side-enclosed model, and the top-covered model. All of them have the same volumes of the soft and hard parts but different shapes. Simulation results show that the switching fields for the three models can be reduced to about 10 kOe （1 Oe = 79.5775 A/m） and the factor gain can be improved to 1.4 when the interface exchange coefficient has a proper value. Compared to the other models, the enclosed model has a wider range of interface exchange coefficient values, in which a low switching field and high gain can be obtained. The dependence of the switching fields on the angle of the applied field shows that none of the three models are easily affected by the stray field of a magnetic head.
The Fex Pt 100x （10nm） （x=31–51） thin films are fabricated on Si （100） substrates by using magnetron sputtering. The highly ordered L1 0 FePt phase is obtained after post-annealing at 700℃in Fe 47 Pt 53 thin film. The sample shows good perpendicular anisotropy with a square loop and a linear loop in the out-of-plane and the in-plane direction, respectively. The variations of the magnetic domains are investigated in the films when the content value of Fe changes from 31% to 51%.
