During the aluminum wire wedge bonding, the ultrasonic power and bonding strength were obtained. Based on those data, the relationship between ultrasonic power and bonding strength was studied. The results show that: 1) ultrasonic power is affected by ultrasonic power ratio and other uncontrolled factors such as asymmetric substrate quality, unstable restriction on the interface between wedge tool and aluminum wire; 2) when ultrasonic power is less than 1.0 W, increasing ultrasonic power leads to increasing bonding strength and decreasing failure bonding; on the contrary, when ultrasonic power is greater than 1.6 W, increasing power leads to decreasing bonding strength and increasing failure bonding; 3) only when ultrasonic power is between 1.0 W and 1.6 W, can stable and high yield bonding be reached. Finally, the microstructure of bonding interface was observed, and a ring-shaped bond pattern is founded in the center and friction scrape besides the ring area.
The driving voltage and current signals of piezoceramic transducer (PZT) were measured directly by designing circuits from ultrasonic generator and using a data acquisition software system. The input impedance and power of PZT were investigated by using root mean square (RMS) calculation. The vibration driven by high frequency was tested by laser Doppler vibrometer (PSV-400-M2). And the thermosonic bonding features were observed by scanning electron microscope (JSM-6360LV). The results show that the input power of bonding is lower than that of no load. The input impedance of bonding is greater than that of no load. Nonlinear phase, plastic flow and expansion period, and strengthening bonding process are shown in the impedance and power curves. The ultrasonic power is in direct proportion to the vibration displacement driven by the power, and greater displacements driven by high power (>5 W) result in welding failure phenomena, such as crack, break, and peeling off in wedge bonding. For thermosonic flip chip bonding, the high power decreases position precision of bonding or results in slippage and rotation phenomena of bumps. To improve reliability and precision of thermosonic bonding, the low ultrasonic power (about 1-5 W) should be chosen.
