Long metal fibers were manufactured in horizontal lathe with a multi-tooth tool. Based on the coarse antler surface structure of copper fibers, a new sintering technology was put forward to manufacture a kind of oriented linear copper fiber sintered felt. The sintering mechanism of oriented linear copper fiber sintered felt was studied. Compared with sintered copper-wire felt, the characteristics of sintered copper-fiber felts were analyzed in details. Owing to the coarse antler surface structure of copper fibers, oriented linear copper-fiber felt was sintered under the condition of micro/nano scale range, and copper fibers easily bonded together in the sintering process. Microchannels with micro-scale coarse antler surface structure were constructed. These characters give oriented linear copper fiber felt some new merits: high filtration accuracy, high flow capability, low resistance loss, good capability to resistance pressure, stable and uniform pore, high specific surface area. The properties of oriented linear copper fiber sintered felt were analyzed.
The outside serrated integral-fin tubes fabricated by rolling-plowing-extrusion processing were surface-treated through different processes of annealing in hydrogen atmosphere,electrochemical corrosion or sandblasting.The purpose was to eliminate residual stress,clear secondary micro-fins and enhance heat transfer performance.By comparing the surface characteristics,it is found that the finned tubes treated by electrochemical corrosion have the most glabrous surfaces where the fins are almost perfectly reserved.Clear layer cracks can be observed on the top of the fins.These structures are effective in enhancing heat transfer performance when being applied to flow heat exchange.Therefore,the finned tubes treated by electrochemical corrosion are proper for the tubular exchanger with water coolant.The finned tubes treated by sandblasting have rougher surfaces with layer cracks and micro gaps removed.As these structures are useful to clearing adhesive feculence,the tubes are more suitable for the tubular heat exchanger with oil coolant.
Boiling structures on evaporation surface of red copper sheet with a diameter (D) of 10 mm and a wall thickness (h) of 1 mm were processed by the ploughing-extrusion (P-E) processing method, which is one part of the phase-change heat sink for high power (HP) light emitting diode (LED). The experimental results show that two different structures of rectangular- and triangular-shaped micro-grooves are formed in P-E process. When P-E depth (ap), interval of helical grooves (dp) and rotation speed (n) are 0.12 mm, 0.2 mm and 100 r/min, respectively, the boiling structures of triangular-shaped grooves with the fin height of 0.15 mm that has good evaporation performance are obtained. The shapes of the boiling structures are restricted by dp and ap, and dp is determined by n and amount of feed (f). The ploughing speed has an important influence on the formation of groove structure in P-E process.
