In2O3 nanoparticles were prepared from or with different indium salts by chemical precipitation under the conditions of various pH values. The crystal structure and ceramic microstructure of the samples were characterized by X-ray diffraction （XRD） and transmission electron microscopy （TEM）. The results show that the mean grain size of In2O3 is less than 100 nm, and their particle homogeneity and dispersibility are satisfactory. The gas sensitivity defined as Ra/Rg was detected in a static system. The results show that the sensors made by as-prepared nanoparticles has high sensitivity to many gases such as alcohol, HCHO, NH3 , et al. The response time is less than 20 s and the recovery time is lower than 30 s.
<正>Flower-like ZnO was prepared through a hydrothermal process using zinc sulfate as raw material.The microstructure and morphology of the samples were characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM).XRD results showed that the as-obtained sample could be indexed to hexagonal wurtzite ZnO.TEM results revealed that the ZnO sample presented flower-like shape.The gas sensors were prepared with the traditional sintering process and their gas sensitivities were detected.The gas sensitivity results showed that the sensors based on flower-like ZnO were very sensitive to dilute 90~# gasoline.The relatively high sensitivity and selectivity of these sensors made from flower-like ZnO demonstrated the potential for developing a new class of selective gasoline sensors.
Nanocrystalline In_2O_3 was synthesized through a controllable solvothermal process in one-step at 210℃for 24 h. Gas sensing properties were tested by mixing gas in air in static state.At 268.5℃,the nanocrystal showed high sensitivity to LPG but lower sensitivity to H_2 and CO.In order to enhance the sensitivities to H_2 and CO,0.5 mass % Au and Pd were doped by an impregnation process.The sensitivities to H_2 and CO were increased under different working temperature.Au-doped In_2O_3 was superior to Pd-doped In_2O_3 whatever to H_2 or CO;the sensitivity was increased with the increase of working temperature;gas sensing properties to H_2 overmatched to CO.
ZnO tetrapod-like whiskers were prepared through a hydrothermal process using zinc powder as raw material.Its microstructure and morphology were characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The XRD results showed that the crystal structure of as-obtained sample can be indexed to hexagonal wurtzite ZnO.TEM results revealed that the ZnO sample took on tetrapod-like whisker shape.The gas sensors were prepared with the traditional sintering process and their gas sensitivities were detected.The test results of gas sensitivity showed that the sensors based on ZnO tetrapod-like whiskers are very sensitive to dilute ethanol vapor and H_2S.The relatively high sensitivity and selectivity of these sensors made from ZnO tetrapod-like whiskers demonstrated the potential for developing a new class of selective ethanol sensors.
Yttrium-doped SnO2 powders were successfully synthesized by solution co-precipitation method and characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The sensitivity of sensors based on Y-doped SnO2 and SnO2 nanocrystals were investigated comparatively. The results indicated that Y-doped SnO2 was with the result of enhancement of sensitivity and selectivity to ethanol and reduction of sensitivity to other gas components. The enhancements of selectivity and sensitivity could be contributed to for two reasons. The first is that rare metal yttrium has a high alkalescence and good catalysis, and the second is that the nanosized crystallite and large specific surface area of Y-doped SnO2 is advantageous for gas-diffusion control as well as an increase in active sites for gas detection.
