A violet laser diode （LD） structure is grown on a free-standing c-plane GaN substrate and 4 μm×800μm ridge waveguide LDs are fabricated. The electrical and the optical characteristics of LDs under different facet-coating and chip-mounting conditions are investigated under pulse mode operation. The active region temperatures of p-side up and p-side down mounted LDs are calculated with different injection currents. The calculated thermal resistances of p-side up and p-side down mounted LDs are 4.6 K/W and 3 K/W, respectively. The threshold current of the p-side down mounted LD is much lower than that of the p-side up mounted LD. The blue shift of the emission wavelength with increasing injection current is observed only for the LD with p-side down mounting configuration, due to the more efficient heat dissipation.
InGaN/GaN multi-quantum-well-structure laser diodes with an array structure are successfully fabricated on sapphire substrates. The laser diode consists of four emitter stripes which share common electrodes on one laser chip. An 800-μm-long cavity is formed by cleaving the substrate along the （1100） orientation using laser scriber. The threshold current and voltage of the laser array diode are 2A and 10.5 V, respectively. A light output peak power of 12 W under pulsed current injection at room temperature is achieved. We simulate the electric properties of GaN based laser diode in a co-planar structure and the results show that minimizing the difference of distances between the different ridges and the n-electrode and increasing the electrical conductivity of the n-type GaN are two effective ways to improve the uniformity of carrier distribution in emitter stripes. Two pairs of emitters on a chip are arranged to be located near the two n-electrode pads on the left and right sides, and the four stripe emitters can laser together. The laser diode shows two sharp peaks of light output at 408 and 409 nm above the threshold current. The full widths at half maximum for the parallel and perpendicular far field patterns are 8° and 32°, respectively.
We present the growth of CaN epilayer on Si （111） substrate with a single A1GaN interlayer sandwiched between the GaN epilayer and A1N buffer layer by using the metalorganic chemical vapour deposition. The influence of the AlN buffer layer thickness on structural properties of the GaN epilayer has been investigated by scanning electron microscopy, atomic force microscopy, optical microscopy and high-resolution x-ray diffraction. It is found that an A1N buffer layer with the appropriate thickness plays an important role in increasing compressive strain and improving crystal quality during the growth of AlGaN interlayer, which can introduce a more compressive strain into the subsequent grown GaN layer, and reduce the crack density and threading dislocation density in GaN film.
InGaN/GaN p-i-n solar cells, each with an undoped In0.12Ga0.88N absorption layer, are grown on c-plane sapphire substrates by metal-organic chemical vapor deposition. The effects of the thickness and dislocation density of the absorp- tion layer on the collection efficiency of InGaN-based solar cells are analyzed, and the experimental results demonstrate that the thickness of the InGaN layer and the dislocation density significantly affect the performance. An optimized InGaN- based solar cell with a peak external quantum efficiency of 57% at a wavelength of 371 nm is reported. The full width at half maximum of the rocking curve of the （0002） InGaN layer is 180 arcsec.
This paper investigates the major structural parameters, such as crystal quality and strain state of （001）-oriented GaN thin films grown on sapphire substrates by metalorganic chemical vapour deposition, using an in-plane grazing incidence x-ray diffraction technique. The results are analysed and compared with a complementary out-of-plane x- ray diffraction technique. The twist of the GaN mosaic structure is determined through the direct grazing incidence t of （100） reflection which agrees well with the result obtained by extrapolation method. The method for directly determining the in-plane lattice parameters of the GaN layers is also presented. Combined with the biaxial strain model, it derives the lattice parameters corresponding to fully relaxed GaN films. The GaN epilayers show an increasing residual compressive stress with increasing layer thickness when the two dimensional growth stage is established, reaching to a maximum level of-0.89 GPa.
High-resolution X-ray diffraction has been employed to investigate the diffuse scattering in a （0001） oriented GaN epitaxial film grown on sapphire substrate. The analysis reveals that defect clusters are present in GaN films and their concentration increases as the density of threading dislocations increases. Meanwhile, the mean radius of these defect clus- ters shows a reverse tendency. This result is explained by the effect of clusters preferentially forming around dislocations, which act as effective sinks for the segregation of point defects. The electric mobility is found to decrease as the cluster concentration increases.
The effects of Mg-induced net acceptor doping concentration and carrier lifetime on the performance of a p-i-n InGaN solar cell are investigated. It is found that the electric field induced by spontaneous and piezoelectric polariza- tion in the i-region could be totally shielded when the Mg-induced net acceptor doping concentration is sufficiently high. The polarization-induced potential barriers are reduced and the short circuit current density is remarkably increased from 0.21 mA/cm2 to 0.95 mA/cm2 by elevating the Mg doping concentration. The carrier lifetime determined by defect density of i-InGaN also plays an important role in determining the photovoltaic properties of solar cell. The short circuit current density severely degrades, and the performance of InGaN solar cell becomes more sensitive to the polarization when carrier lifetime is lower than the transit time. This study demonstrates that the crystal quality of InGaN absorption layer is one of the most important challenges in realizing high efficiency InGaN solar cells.
In situ optical reflectivity measurements are employed to monitor the GaN epilayer growth process above a lowtemperature GaN buffer layer on a c-plane sapphire substrate by metalorganic chemical vapour deposition. It is found that the lateral growth of the GaN islands and their coalescence are promoted in the initial growth stage if optimized nitridation time and temperature are selected when the substrate is pre-exposed to ammonia. As confirmed by atomic force microscopy observations, the quality of the CaN epilayers is closely dependent on the surface morphology of the nitridated buffer layer, especially grain size and nucleation density.
High-quality and nearly crack-free GaN epitaxial layer was obtained by inserting a single A1GaN interlayer between GaN epilayer and high-temperature AlN buffer layer on Si （111） substrate by metalorganic chemical vapor deposition. This paper investigates the effect of AlCaN interlayer on the structural properties of the resulting CaN epilayer. It confirms from the optical microscopy and Raman scattering spectroscopy that the AIGaN interlayer has a remarkable effect on introducing relative compressive strain to the top GaN layer and preventing the formation of cracks. X-ray diffraction and transmission electron microscopy analysis reveal that a significant reduction in both screw and edge threading dislocations is achieved in GaN epilayer by the insertion of AlGaN interlayer. The process of threading dislocation reduction in both AlGaN interlayer and GaN epilayer is demonstrated.
