The effects of Cu on stacking fault energy,dislocation slip,mechanical twinning,and strain hardening in Fe–20Mn–1.3C twinning-induced plasticity(TWIP) steels were systematically investigated.The stacking fault energy was raised with an average slope of 2 mJ/m2 per 1 wt% Cu.The Fe–20Mn–1.3C–3Cu steel exhibited superior tensile properties,with the ultimate tensile strength reached at 2.27 GPa and elongation up to 96.9% owing to the high strain hardening that occurred.To examine the mechanism of this high strain hardening,dislocation density determination by XRD was calculated.The dislocation density increased with the increasing strain,and the addition of Cu resulted in a decrease in the dislocation density.A comparison of the strain-hardening behavior of Fe–20Mn–1.3C and Fe–20Mn–1.3C–3Cu TWIP steels was made in terms of modified Crussard–Jaoul(C–J) analysis and microstructural observations.Especially at low strains,the contributions of all the relevant deformation mechanisms—slip,twinning,and dynamic strain aging—were quantitatively evaluated.The analysis revealed that the dislocation storage was the leading factor to the increase of the strain hardening,while dynamic strain aging was a minor contributor to strain hardening.Twinning,which interacted with the matrix,acted as an effective barrier to dislocation motion.
Lingyan ZhaoDingyi ZhuLonglong LiuZhenming HuMingjie Wang
The characterization of reactive solid-liquid interfacial energies and solid surface energies is a pressing problem in materials science and surface science. Based on the concept that unbalanced forces doing work, a mathematical formulation between surface energies and interfacial energies for reactive wetting is presented. The resulting formalism has significant generality in which the equilibrium Young's equation for solid-liquid interfacial energies is just a special case. It is shown that a solid-liquid interfacial energy at non-equilibrium is always higher than that at equilibrium, and that the transformation of reactive interfaces to equilib-rium interfaces is an inevitable, spontaneous process. The numerical range of solid-liquid interfacial energies γsl for a limited, solid-liquid interfacial wetting system was calculated to be 0 ≤γsl ≤γsg. The calculation methods for reactive solid-liquid interfacial energies and solid surface energies are presented. They are significant for composite materials and weld, powder sinter, package of electronic devices, and other surface and interfacial issues in metallurgy.
