Dynamic Monte Carlo simulations of bulk lattice polymers driven through planar geometries with sequentially converging,parallel and diverging spaces between two neutrally repulsive solid plates are reported.The spatial profiles of polymer velocity and deformation along the course of such a laminar extensional flow have been carefully analyzed.The results appear consistent with experimental observations in literature.In the entrance and exit regions,a linear dependence of chain extension upon the excess velocity has been observed.Moreover,an annexed shear flow and a molecular-dispersion effect are found.The results demonstrate a useful strategy of this approach to study polymer flows and bring new insights into the non-Newtonian-fluid behaviors of bulk polymers in capillary rheometers and micro-fluidic devices.
Network polymers in a rubber or a gel often contain non-uniform chain lengths. By means of dynamic Monte Carlo simulations of polymer mixtures with various compositions of two chain lengths, we investigated how the factor of polydispersity influences their strain-induced crystal nucleation. Under a high temperature and a high strain rate, the stretching of both polymers revealed that crystal nucleation is mainly accelerated by the presence of short-chain polymers; nevertheless, both polymers join together in the nucleation process. Further analysis proved that crystal nucleation is initiated from those highly stretched short segments, which are rich on the short-chain polymers.
By means of dynamic Monte Carlo simulation of bulk lattice polymers in Couette shear flow, it was demonstrated that in addition to velocity gradient the constant driving forces acting as the activation aspect of shear stresses can also raise polymer deformation. Moreover, enhancing driving forces in a flow without any velocity gradient can reproduce nonNewtonian fluid behaviors of long-chain polymers. The simulations of Poiseuille shear flow with a gradient of shear stresses show that, the velocity gradient dominates small deformation in the flow layers of low shear stresses, while the shear stress dominates large deformation in the flow layers of high shear stresses. This result implies that the stress-induced deformation could be mainly responsible for the occurrence of non-Newtonian fluid behaviors of real polymers at high shear rates.
