The microstructure scales of dendrites, such as primary and secondary dendrite arm spacings, control the segregation profiles and the formation of secondary phases within interdendritic regions, which determine the properties of solidified structures. Investigations on primary and secondary dendrite arm spacings of primary a-phase during directionally solidified Pb-26wt%Bi hypo-peritectic alloy were carried out in this research, and systematic studies were conducted using cylindrical samples with different diameters （Ф = 1.8 and 7.0 mm） in order to analyze the effects of sample diameter on the primary and secondary dendrite arm spacings. In this work, the dependence of dendrite arm spacings on growth velocity was established. In addition, the experimental data concerning the primary and secondary dendrite ann spacings were compared with the main predictive dendritic models from the literatures. A comparison between experimental results for dendrite arm spacings of the 1.8-mm-diameter sample and 7.0-ram-diameter sample was also conducted.
HU XiaowuYAN HongCHEN WenjingLI ShuangmingFU Hengzhi
This paper investigated the influences of pouring temperature and cooling rate on the microstructure development and mechanical properties for casting A1-Si-Cu aluminum alloy. The microstructure of the as-cast samples was characterized by an optical microscope. The results showed that the dendrite arm spacing （DAS,）,） is well refined by pouring at a higher temperature. The A decreases with increasing pouring temperature due to the multiplication of the nucleation sites in the superheating liquid melt, and the mechanical properties, such as microhardness and ultimate tensile strength increase correspondingly, while the elongation decreases. The relationships between microhardness and 3, for the samples cooled in metal mould and sand mould, are given as HV：l18.9 - 1.246A and HV=l15.2- 1.029A, respectively. The effects of the cooling rate controlled by using permanent mould casting and sand mould casing processes （the cooling medium is air and sand, respectively） on the dendrite arm spacing and mechanical properties are similar to the effect of the pouring temperature.
In this work,the Sn-58Bi(weight percent) eutectic alloy was directionally solidified at a constant temperature gradient(G = 12 K.mm-1) with different growth rates using a Bridgman type directional solidification furnace.A lamellar microstructure was observed in the Sn-58Bi samples.The lamellar spacing and micro-hardness of longitudinal and transversal sections were measured.The values of lamellar spacing of both longitudinal and transversal sections decrease with an increase in growth rate.The microhardness increases with an increase in the growth rate and decreases with an increase in the lamellar spacing.The dependence of lamellar spacing on growth rate,and micro-hardness on both growth rate and lamellar spacing were obtained by linear regression analysis.The relationships between the lamellar spacing and growth rate,microhardness and growth rate,and micro-hardness and lamellar spacing for transversal and longitudinal sections of Sn-58Bi eutectic alloy were given.The fitted exponent values obtained in this work were compared with the previous similar experimental results and a good agreement was obtained.
