Using density functional theory, the electronic structures, lattice constants, formation energies, and optical properties of Al_xGa_(1-x)N are determined with Al component content x in a range from 0 to 1. As x increases, the lattice constants decrease in e-exponential form, and the band gap increases with a band bending parameter b=0.3954. The N–Al interaction force in the(0001) direction is greater than the N–Ga interaction force, while the N–Al interaction force is less than the N–Ga interaction force in the(10ī0) direction. The formation energies under different Al component content are negative and increase with Al component content increasing. The static dielectric function decreases, the absorption edge has a blue shift, and the energy loss spectrum moves to high energy with the Al component content increasing.
We employ plane-wave with ultrasoft pseudopotential method to calculate and compare the total density of states and partial density of states of bulk-phase GaN,Ga0.9375 N,and GaN0.9375 systems based on the first-principle density-functional theory(DFT).For Ga and N vacancies,the electronic structures of their neighbor and next-neighbor atoms change partially.The Ga0.9375 N system has n-type semiconductor conductive properties,whereas the GaN0.9375 system has p-type semiconductor conductive properties.By studying the optical properties,the influence of Ga and N vacancy defects on the optical properties of GaN has been shown as mainly in the low-energy area and very weak in high-energy area.The dielectric peak influenced by vacancy defects expands to the visible light area,which greatly increases the electronic transition in visible light area.
对微通道板(Micro-Channel Plate,MCP)的电子输运特性进行仿真研究.利用数值方法分析微光像增强器电子光学系统,得到电场分布.通过电场分布追踪MCP电子运动轨迹,确定电子在荧光屏像面上的落点分布.据此研究MCP电子输运,分析斜切角、通道直径及两端电压对电子输运、像增强器调制传递函数(Modulation Transfer Function,MTF)及分辨率的影响.结果显示,当MCP斜切角为14°、通道直径为5.0μm、两端电压为900 V时,MCP具有良好的电子输运特性,像增强器MTF特性好,分辨率高.
The electronic structure and optical properties of Al and Mg co-doped GaN are calculated from first principles using density function theory with the plane-wave ultrasoft pseudopotential method.The results show that the optimal form of p-type GaN is obtained with an appropriate Al:Mg co-doping ratio rather than with only Mg doping.Al doping weakens the interaction between Ga and N,resulting in the Ga 4s states moving to a high energy region and the system band gap widening.The optical properties of the co-doped system are calculated and compared with those of undoped GaN.The dielectric function of the co-doped system is anisotropic in the low energy region.The static refractive index and reflectivity increase,and absorption coefficient decreases.This provides the theoretical foundation for the design and application of Al–Mg co-doped GaN photoelectric materials.
The adsorption characteristics of Cs on GaN(0001) and GaN(000) surfaces with a coverage from 1/4 to 1 monolayer have been investigated using the density functional theory with a plane-wave ultrasoft pseudopotential method based on first-principles calculations.The results show that the most stable position of the Cs adatom on the GaN(0001) surface is at the N-bridge site for 1/4 monolayer coverage.As the coverage of Cs atoms at the N-bridge site is increased,the adsorption energy reduces.As the Cs atoms achieve saturation,the adsorption is no longer stable when the coverage is 3/4 monolayer.The work function achieves its minimum value when the Cs adatom coverage is 2/4 monolayer,and then rises with Cs atomic coverage.The most stable position of Cs adatoms on the GaN(000) surface is at H3 site for 1/4 monolayer coverage.As the Cs atomic coverage at H3 site is increased,the adsorption energy reduces,and the adsorption is still stable when the Cs adatom coverage is 1 monolayer.The work function reduces persistently,and does not rise with the increase of Cs coverage.
