A new method to modify the solidification microstructure of titanium alloys, named melt hydrogenation, by adding TiH2 as additive into the melt of titanium alloys during induction skull melting process (ISM), is put forward and the refining effect of this method on the solidification microstructure of Ti-6Al-4V alloy was studied experimentally. After melt hydrogenation, the grain sizes of as-cast Ti-6Al-4V alloy decreased to 612 μm from 1,072 μm, lath-shaped α phase was also refined and fine α/β lamellar microstructure was formed when 1.0 wt.% TiH2 was added. δ-hydride was found in the X-ray diffraction (XRD) spectra of Ti-6Al-4V alloy that prepared with 1.0 wt.% TiH2 added and the δ-hydride distributes in α phase as acicular precipitations.
Peritectic reaction was studied by directional solidification of Cu-Ge alloys.A larger triple junction region of peritectic reaction was used to analyze the interface stability of the triple junction region during peritectic reaction.Under different growth conditions and compositions,different growth morphologies of triple junction region are presented.For the hypoperitectic Cu-13.5%Ge alloy,as the pulling velocity（v） increases from 2 to 5 μm/s,the morphological instability of the peritectic phase occurs during the peritectic reaction and the remelting interface of the primary phase is relatively stable.However,for the hyperperitectic Cu-15.6%Ge alloy wim v=5 μm/s,the nonplanar remelting interface near the trijunction is presented.The morphological stabilities of the solidifying peritectic phase and the remelting primary phase are analyzed in terms of the constitutional undercooling criterion.
The fracture behavior of fully lamellar γ-TiAl alloys depends on the angle between the lamellar orientation and loading axis,but the role of the presentation of grain boundary cannot be ignored.To investigate the influence of the grain boundary on the initiation and propagation of cracks,the tensile test of the alloy was conducted at room temperature with loading axis parallel and perpendicular to the lamellar orientation,respectively.The cracks adjacent to the fracture zone of the tensile specimens have been investigated to analyze the fracture behavior.Results show that the grain boundary has dual influences on the fracture behavior.When the loading axis is parallel to the lamellar orientation,cracks are preferentially initiated at and propagate along the grain boundaries.When the loading axis is perpendicular to the lamellar orientation,the grain boundaries can prevent the propagation of cracks from running across.Additionally,serrated-shape grain boundaries have a better inhibiting effect on the propagation of cracks than planar boundaries.
