Atmospheric air discharge above the surface of water is an effective method for water treatment.The leakage current and Joule heating of water are reduced by the air gap,which raises the energy efficiency of the water treatment.However,the application of this kind of discharge is limited by a pair of conflicting factors:the chemical efficiency grows as the discharge gap distance decreases,while the spark breakdown voltage decreases as the gap distance decreases.To raise the spark breakdown voltage and the chemical efficiency of atmospheric pressure water surface discharge,both the high-voltage electrode and the ground electrode are suspended above the water surface to form an electrode-water-electrode discharge system.For this system,there are two potential discharge directions:from one electrode to another directly,and from the electrodes to the water surface.The first step in utilizing the electrode-water-electrode discharge is to find out the discharge direction transition criterion.In this paper,the discharge direction transition criterions of spark discharge and streamer discharge are presented.By comparing the discharge characteristics and the chemical efficiencies,the discharge propagating from the electrodes to the water surface is proved to be more suitable for water treatment than that propagating directly between the electrodes.
The influence of metal ions, such as Fe2+ , Fe3+ , Cu2+ and Mn2+ , on 4-CP degrada- tion was investigated in an aqueous pulsed discharge plasma system with or without the addition of a TiO 2 photo-catalyst. From an analysis of the pseudo first-order rate constant (k CP ) and energy efficiency (G 50% ) for 4-CP degradation, the experimental results show that the degradation of 4-CP is much enhanced in the presence of ferrous ions at the optimal concentration of 0.2～0.8 mmol/L or 0.2 mmol/L in an aqueous pulsed discharge plasma without or with the TiO2 system, respectively, and the enhancement is ascribed to plasma induced Fenton and photo-Fenton reactions. Meanwhile, the rank of such metal ions for catalytic effect on 4-CP degradation was Fe2+ > Fe3+ > Cu2+ > Mn2+ and Fe2+ > Fe3+ > Mn2+ > Cu2+ for the former and the latter systems, respectively, and the reasons behind this were discussed through the analysis of active species, especially hydrogen peroxide.
