A simple and practical method for the synthesis of zeolite 4A from bauxite tailings is presented in this paper. Systematic investigations were carried out regarding the capacity of zeolite 4A to remove Cr（III） from aqueous solutions with relatively low initial concentrations of Cr（III）（5–100 mg·L^（-1））. It is found that the new method is extremely cost-effective and can significantly contribute in decreasing environmental pollution caused by the dumping of bauxite tailings. The Cr（III） removal capacity highly depends on the initial p H value and concentration of Cr（III） in the solution. The maximum removal capacity of Cr（III） was evaluated to be 85.1 mg×g^（-1） for zeolite 4A, measured at an initial p H value of 4 and an initial Cr（III） concentration of 5 mg·L^（-1）. This approach enables a higher removal capacity at lower concentrations of Cr（III）, which is a clear advantage over the chemical precipitation method. The removal mechanism of Cr（III） by zeolite 4A was examined. The results suggest that both ion exchange and the surface adsorption-crystallization reaction are critical steps. These two steps collectively resulted in the high removal capacity of zeolite 4A to remove Cr（III）.
