您的位置: 专家智库 > >

国家自然科学基金(51075098)

作品数:3 被引量:28H指数:3
相关作者:胡连喜孙宇徐岩贾建波姜巨福更多>>
相关机构:哈尔滨工业大学北华大学更多>>
发文基金:国家自然科学基金更多>>
相关领域:一般工业技术金属学及工艺化学工程更多>>

文献类型

  • 3篇中文期刊文章

领域

  • 3篇金属学及工艺
  • 3篇一般工业技术
  • 1篇化学工程

主题

  • 3篇镁合金
  • 3篇合金
  • 2篇英文
  • 2篇AZ91D镁...
  • 1篇动力学模型
  • 1篇应变速率
  • 1篇应变速率敏感...
  • 1篇再结晶
  • 1篇再结晶行为
  • 1篇塑性
  • 1篇塑性变形
  • 1篇热变形
  • 1篇热变形行为
  • 1篇铸态
  • 1篇组织与力学性...
  • 1篇力学模型
  • 1篇力学性能
  • 1篇流变应力
  • 1篇晶粒
  • 1篇晶粒细化

机构

  • 2篇北华大学
  • 2篇哈尔滨工业大...

作者

  • 2篇徐岩
  • 2篇孙宇
  • 2篇胡连喜
  • 1篇姜巨福
  • 1篇贾建波

传媒

  • 2篇Transa...
  • 1篇Rare M...

年份

  • 1篇2015
  • 1篇2014
  • 1篇2013
3 条 记 录,以下是 1-3
排序方式:
铸态AZ91D镁合金的动态再结晶动力学(英文)被引量:14
2014年
在温度为220~380℃和应变速率为0.001~1s^(-1)的条件下进行等温热压缩,研究铸态AZ91D镁合金的变形行为和动态再结晶行为。讨论变形温度和应变速率对动态再结晶行为的影响。结果表明,动态再结晶晶粒的形核和长大极易在高温和低应变速率的条件下发生。为预测动态再结晶的演变过程,在真实应力—应变曲线数据的基础上,提出AZ91D镁合金的动态再结晶动力学模型。该模型揭示动态再结晶的体积分数随着真实应变的增加而增加,其增长趋势呈典型的"S"曲线。通过对比发现由动力学模型所预测的结果和微观组织观测的数据具有很好的一致性,验证了所建立的AZ91D镁合金动态再结晶动力学模型的准确性。
徐岩胡连喜孙宇
关键词:AZ91D镁合金动力学模型
循环镦-挤制备AZ61镁合金的显微组织与力学性能(英文)被引量:11
2015年
在温度为285~380℃的条件下,采用循环镦一挤工艺成功获得AZ61镁合金的累积大塑性变形,并对铸态和循环镦一挤变形后合金的组织特征和力学性能进行研究。结果表明,在285℃的条件下,循环镦一挤变形3道次后,材料获得的累积应变为4.28,并得到了平均晶粒尺寸为3.5min的细小均匀的微观组织。晶粒细化的主要原因是局部应变引起的动态再结晶。结果还表明,显微组织演变受温度和累积变形程度的影响。晶粒细化使循环镦一挤变形的AZ61镁合金的力学性能得到明显的改善。此外,通过室温拉伸试验揭示了循环镦一挤工艺参数与力学性能之间的关系。
徐岩胡连喜孙宇贾建波姜巨福马庆国
关键词:AZ61镁合金大塑性变形晶粒细化力学性能
Hot deformation behavior and microstructure evolution of as-cast AZ91D magnesium alloy without pre-homogenization treatment被引量:3
2013年
The deformation behavior and the microstructure evolution of as-cast AZ91D magnesium alloy without pre-homogenization treatment were systematically investigated.The flow stress behavior was studied by compression tests in strain rate range of 0.001–1.000 s-1and deformation temperature range of 220–380°C with a maximum deformation strain of 60%.The dependence of flow stress on deformation temperature and strain rate was described by hyperbolic sine constitutive equation.Through regression analysis,the average apparent activation energy and coefficient of strain rate sensitivity were estimated to be 181.98 kJámol-1and 0.14,respectively.The results also reveal that the variation of peak stress depends on strain rate and deformation temperature.Microstructure observation shows that,at temperatures higher than 300°C and strain rates lower than 0.01 s-1,DRX developed extensively at the grain boundaries and in the core of coarse grains,resulting in a more homogeneous microstructure.Furthermore,the effects of strain,deformation temperature,strain rate,and eutectic b phase on the microstructure evolution of as-cast AZ91D magnesium alloy were discussed.
Yan XuLian-Xi HuYu Sun
关键词:AZ91D镁合金热变形行为应变速率敏感性流变应力
共1页<1>
聚类工具0