The effective index of the cladding fundamental space-filling mode in photonic crystal fiber (PCF) is simulated by the effective index method. The variation of the effective index with the structure parameters of the fiber is achieved. For the first time, the relations of the V parameter of Yb3+-doped PCF with the refractive index of core and the structure parameters of the fiber are provided. the single-mode characteristics of large-core Yb3+-doped photonic crystal fibers with 7 and 19 missing air holes in the core are analyzed. The large-core single-mode Yb3+-doped photonic crystal fibers with core diameters of 50 μm, 100 μm and 150 μm are designed. The results provide theory instruction for the design and fabrication of fiber.
In this paper a high-repetition-rate mid-infrared （mid-IR） optical parametric oscillator based on periodically poled MgO-doped LiNbO3 （PPMgLN） at room temperature was demonstrated. The maximum average mid-IR output power at 3.63μm was 1.02 W with the repetition rate of 60kHz and corresponding efficiency from the pump to the idler was 26.7%. The temperature tuning and the period tuning characteristics were also discussed.
In this paper, a 120-fs pulse transmission experiment is carried out using disordered birefringent microstructure fibers with cladding ventages. Through this experiment, it is found for the first time that remarkable Stokes and anti-Stokes waves can also be produced when the central wavelength of the incident pulse is in the normal dispersion regime of the microstructure fiber. The generation of the two waves can be explained by the four-wave mixing phase matching theory. Properties of the two waves under the action of femtosecond laser pulses with different parameters are studied. The results show that the central wavelength of anti-Stokes waves and Stokes waves produced under the two orthogonal polarization states shift by 63 nm and 160 nm, respectively. The strengths and central positions of the two waves in birefringent fibers can be controlled by adjusting the phase match condition and the polarization directions of incident pulses.
We have made a gain-switched all-solid-state quasi-continuous-wave （QCW） tunable Ti：sapphire laser system, which is pumped by a 532 nm intracavity frequency-doubled Nd：YAG laser. Based on the theory of gain-switching and the study on the influencing factors of the output pulse width, an effective method for obtaining high power and narrow pulse width output is proposed. Through deliberately designing the pump source and the resonator of the Ti：sapphire laser, when the repetition rate is 6 kHz and the length of the cavity is 220 mm, at an incident pump power of 22 W, the tunable Ti：sapphire laser from 700 to 950nm can be achieved. It has a maximum average output power of 5.6W at 800nm and the pulse width of 13.2 ns, giving an optical conversion efficiency of 25.5% from the 532 mn pump laser to the Ti：sapphire laser.
In this paper we report on a continuous-wave （CW） intracavity singly resonant optical parametric oscillator （ICSRO） based on periodically poled LiNbO3 （PPLN） pumped by a diode-end-pumped CW Nd：YVO4 laser. Considering the thermal lens effects and diffraction loss, an optical ballast lens and a near-concentric cavity are adopted for better operation. Through varying the grating period and the temperature, the tunable signal output from 1406 nm to 1513 nm is obtained. At a PPLN grating period of 29 pm and a temperature of 413 K, a maximum signal output power of 820 mW at 1500 nm is achieved when the 808 nm pump power is 10.9 W, leading to an optical-to-optical conversion efficiency of 7.51%.
