Epitaxial La 2/3 Ca 1/3 MnO 3 thin films grown on LaAlO 3 (001) substrates were irradiated with low-energy 120-keV H 2 + ions over doses ranging from 10 12 ions/cm 2 to 10 17 ions/cm 2 . The irradiation suppresses the intrinsic insulator-metal (I-M) transition temperature and increases the resistance by reducing the crystallographic symmetry of the films. No irradiation-induced columnar defects were observed in any of the samples. The specific film irradiated at a critical dose around 8 × 10 15 ions/cm 2 is in a threshold state of the electric insulator where the I-M transition is absent. In an external field of 4 T or higher, the I-M transition is restored and thus an enormous magnetoresistance is observed, while a negative temperature coefficient resumes as the temperature is reduced further. Magnetic relaxation behavior is confirmed in this and other heavily irradiated samples. The results are interpreted in terms of the displacement of oxygen atoms provoked by ion irradiation and the resulting magnetic glassy state, which can be driven into a phase coexistence of metallic ferromagnetic droplets and the insulating glass matrix in a magnetic field.
We carry out an ultra-low-field nuclear magnetic resonance (NMR) experiment based on high-T c superconducting quantum interference devices (SQUIDs). The measurement field is in a micro-tesla range (～10 μT-100 μT) and the experiment is conducted in a home-made magnetically-shielded-room (MSR). The measurements are performed by the indirect coupling method in which the signal of nuclei precession is indirectly coupled to the SQUID through a tuned copper coil transformer. In such an arrangement, the interferences of applied measurement and polarization field to the SQUID sensor are avoided and the performance of the SQUID is not destroyed. In order to compare the detection sensitivity obtained by using the SQUID with that achieved using a conventional low-noise-amplifier, we perform the measurements using a commercial room temperature amplifier. The results show that in a wide frequency range (～1 kHz-10 kHz) the measurements with the SQUID sensor exhibit a higher signal-to-noise ratio. Further, we discuss the dependence of NMR peak magnitude on measurement frequency. We attribute the reduction of the peak magnitude at high frequency to the increased field inhomogeneity as the measurement field increases. This is verified by compensating the field gradient using three sets of gradient coils.
Besides serving as promising candidates for realizing quantum computing,superconducting quantum circuits are one of a few macroscopic physical systems in which fundamental quantum phenomena can be directly demonstrated and tested,giving rise to a vast field of intensive research work both theoretically and experimentally.In this paper we report our work on the fabrication of superconducting quantum circuits,starting from its building blocks:Al/AlOx /Al Josephson junctions.By using electron beam lithography patterning and shadow evaporation,we have fabricated aluminum Josephson junctions with a controllable critical current density(jc) and wide range of junction sizes from 0.01 μm2 up to 1 μm2.We have carried out systematical studies on the oxidation process in fabricating Al/AlOx/Al Josephson junctions suitable for superconducting flux qubits.Furthermore,we have also fabricated superconducting quantum circuits such as superconducting flux qubits and charge-flux qubits.
Measurements of three-junction flux qubits, both single flux qubits and coupled flux qubits, using a coupled direct current superconducting quantum interference device (dc-SQUID) for readout are reported. The measurement procedure is described in detail. We performed spectroscopy measurements and coherent manipulations of the qubit states on a single flux qubit, demonstrating quantum energy levels and Rabi oscillations, with Rabi oscillation decay time TRabi = 78 ns and energy relaxation time T1 = 315 ns. We found that the value of T Rabi depends strongly on the mutual inductance between the qubit and the magnetic coil. We also performed spectroscopy measurements on inductively coupled flux qubits.
