During the test on transient pressure signal in explosion field,false trigger caused by field interference can lead to test failure.To improve the stability of test system,a signal detection and recognition technology is proposed for transient pressure test system.In the process of signal acquisition,firstly,electrical levels are monitored in real time to find effective abrupt changes and mark them;then the effective data segments are detecdted totected;thus the effective signals can be acquired in turn finally.The experimental results show that the shock wave signal can be collected effectively and the reliability of the test system can be improved after removal of interferences.
Because single trigger system is unreliable for shock wave overpressure test, this paper presents a multi-trigger overpressure test system. The large memory capacity is divided into parts to achieve data acquisition and storage with multiple triggers. Compared with conventional single-shot storage test system, this system can prevent false trigger and improve reliability of the test. By using explosion time to extract valid signal segments, it improves the efficiency of data recovery. These characteristics of the system contribute to multi-point test. After the dynamic characteristics of the system are calibrated, the valid data can be obtained in explosion experiments. The results show that the multi-trigger test system has higher reliability than single trigger test system.